Pellet ignition depends on a heating element reaching the fuel bed reliably at every startup, and this ignitor tube with mounting flange is the Enviro part that does that job. The Enviro Empress Pellet Stove Ignitor Tube with Mounting Flange (part 50-1355) replaces the worn ignitor assembly in Enviro Empress freestanding pellet stoves.

Key Benefits

• Restores consistent startup ignition instead of intermittent or failed light-off
• Genuine Enviro part built to the original tube and flange dimensions
• Ships new in original Enviro packaging
• Addresses a common failure point — ignitors that stop heating over time

Purpose

The ignitor tube heats up on startup to ignite the pellet fuel bed. If the current ignitor no longer heats, it typically needs replacement rather than repair.

Other Notes

This ignitor is known to be tricky to install; some technicians tie a string to the ignitor wires before removal so the string runs through the stove and makes pulling the new wires into place easier.

While replacing the ignitor, it's worth inspecting the exhaust and combustion blowers, gaskets, and the auger motor, since these components see similar operating stress and wear over a comparable service life.

Not sure it fits your unit? Contact us with your model number and we'll confirm before you order.