When a gas fireplace stops responding to its handheld remote, the fault often sits at the receiver rather than the transmitter. The Enviro Digital Fireplace Controller SP1 (part 50-2005) replaces the worn remote control receiver, also called the digital burner control, in compatible Enviro gas fireplaces and inserts. It is a SIT Proflame 1 WHT receiver supplied as a genuine Enviro part.

Purpose

The receiver interprets the signal sent by the handheld remote transmitter and translates it into the ignition and flame commands the burner assembly carries out.

Key Benefits

• Restores consistent remote response and flame control
• Returns the appliance to its original signal range and syncing performance
• Genuine Enviro component, not an aftermarket equivalent
• Ships new in original packaging

Other Notes

Before replacing the receiver, check remote batteries and confirm both components are within normal operating distance and properly synced, since these are the most common causes of a non-responsive remote.

If troubleshooting points to signal or syncing problems rather than the receiver itself, also inspect the handheld transmitter, and consider the full remote control kit if either half is original to the appliance. This part fits 3 compatible models on record.

Not sure it fits your unit? Contact us with your model number and we'll confirm before you order.